anthonyt64
anthonyt64
Today at 1:25 PM
Mathematics
Answered
answer these two, please
Answer :
jorgec9657
jorgec9657
Today at 1:31 PM
Answer:#1 b #2 b
Step-by-step explanation:
Answer Link
katherine8277
katherine8277
Today at 1:31 PM
1b and 2 b to _______
Answer Link
VIEW ALL ANSWERS ( 91+ )
Other Questions
For the axial loaded spiral circular column of diameter (300) mm, Asst=3000mm2, fc=28MPa ,fY=400MPa & a=0.85. The nominal section strength Pn is?
Why did the founding fathers deny certain powers to the national government state government or both?
Why did the german army had good uniforms?
Why did the founding fathers deny certain powers to the national government state government or both?
For the axial loaded spiral circular column of diameter (300) mm, Asst=3000mm2, fc=28MPa ,fY=400MPa & a=0.85. The nominal section strength Pn is?
who is Roobesh Kannan
Highlight the importance of the study of social interaction to better understand a society also discuss the importance of space and time in interaction
two concentric circles radii 12 and 15 a chord of bigger circle becomes a tangent of smaller circle then the length of chord is
re write the sentence without using and ,so,but Q: He remained absent on friday.It was foolish of him.
write any four polyhedrons
Why does the moon have a layer of powdery "soil" on its surface?
(a) m³/s A broad-crested weir is located in a wide prismatic channel with a bed surface slope of So=2×10 with a discharge per unit width of q=1.5 m The bed surf
A column 300 x 300 mm supports a dead load of 948 kN and a live load of 744 kN. The allowable soil bearing pressure is 262 kPa. The base of the footing is 1.7 m
Determine the volume (m3 ) of three identical activated-sludge tanks following primary clarification to aerate 38,000 m3 /d with a BOD concentration of 170 mg/l
Geotechnical engineer is required to carry out preliminary and detailed site investigation of a project before proceed with design and construction stage. As a
What is the minimum width of a square footing needed to support a total service load (i.e.
Determine the design strength of the cantilever beam (properties given below) and the safe uniform service live load if the service dead load is 320 kN-m. Use f
Determine the maximum load that can be applied on the beam shown in figure if the stresses in the material of the beam section is limited to the following:- All
Type X gypsum board O a. resists impace O b. is used in areas that require fire ratings O c. is used as a tile backer board O d. is moisture resistant
Why does the respiratory system need to pass oxygen to the blood?
