nataliestacey2008 nataliestacey2008

Today at 6:47 AM
Mathematics

Answered

I need help I don’t understand this at all

I need help I don’t understand this at all class=

Answer :

calvins7316 calvins7316

Today at 6:52 AM

Answer:

it is 60

Step-by-step explanation:

1= what, well its 60

Answer Link

sleepy24 sleepy24

Today at 6:52 AM

The value of y is 60 when x is in 1

Answer Link

Other Questions

Transcription rates with a combination of enhancers + activators vs silencers + repressors? a) Increased by enhancers + activators, decreased by silencers + rep

Marked unilateral kidney atrophy is suggestive of ? a) Polycystic kidney disease b) Renal artery stenosis c) Renal vein thrombosis d) Renal tuberculosis

What causes the formation of hairpin loops in RNA in Intrinsic termination (rho-independent) & what causes Uracils? a) DNA binding proteins b) RNA polymerase c)

Primary growth originates from apical meristems at the root and shoot tip. A. True B. False

What causes the formation of hairpin loops in RNA in Intrinsic termination (rho-independent) & what causes Uracils? a) DNA binding proteins b) RNA polymerase c)

Siya said that she was in the house when the alarm went on change into Direct speech

+(a)9-3-2(d(c) 1751

Write a short note about the zuan zang

what are Canal rays

in the set of whole number,the valid operation among the following is

What are the four major groupings for carbon steel and/or stainless steel tube?

State the colour code for each of the copper types?

Compression type tube benders are usually limited to what size of tube?

Which type of tube bundle is best suited for application requiring frequent bends or turns?

The suggested maximum allowable working pressure of a 1/4" (6.4mm) O.D. nylon tube is? A - 150 psi B - 250 psi C - 350 psi D - 450 psi

List the eight (8) basic types of valves available?

What is the purpose of the placement link on a hand tube bender? A. To measure the angle of the bend B. To align the tubing in the correct position C. To secure

State the two principle functions or reasons for the use of valves?

The stem of an operational split wedge gate valve must be in the? A - Open position B - Closed position C - Partially open position D - Any position

Explain why gate valves should not be used in the partially open or closed position?